Every Kratky tomato starts the same way: a seed in a soil-free starter cube, kept warm and moist until it has roots long enough to reach the nutrient solution. Starting tomato seeds for Kratky is simpler than starting them for the garden, because there is no potting up and no soil to manage. The seedling goes straight from its cube into a net cup.
What You Need
- Starter cubes or plugs. Rockwool cubes, or peat or coco starter plugs. They hold water and air, and they fit inside a net cup.
- Tomato seeds. Pick the variety for the container you have. See tomato varieties for Kratky hydroponics.
- A tray and a clear cover to keep the humidity up while the seeds germinate.
- Warmth. Tomato seeds germinate best at about 70 to 80°F. A seedling heat mat helps in a cool room.
- A light for as soon as the seedlings come up. See grow lights for indoor tomatoes.
Sowing, Step by Step
- Soak the cubes. Rockwool should be soaked in water adjusted to about pH 5.5 before sowing, because new rockwool can push the pH up. Squeeze out the excess so the cube is moist, not dripping.
- Sow one or two seeds per cube, about a quarter inch deep, and pinch the hole closed.
- Cover the tray and keep it warm. Most tomato seeds sprout in about 5 to 10 days.
- Uncover and give light as soon as the first seedlings appear. Seedlings left in the dark, or under weak light, stretch into long, pale stems that flop over.
- Thin to one seedling per cube once the first true leaves appear, by snipping the weaker one at the base.
Feeding Seedlings
A seed carries enough food for its first leaves, so plain pH-adjusted water is enough until the first true leaves open. After that, water the cubes with nutrient solution at a quarter to half the strength the label gives for mature plants. Seedlings fed at full strength can burn.
When the Seedling Is Ready for Kratky
Move a seedling into its Kratky container when white roots show through the bottom of the cube and it has a set or two of true leaves. Set the cube in the net cup, fill around it with clay pebbles, and fill the container until the solution just touches the bottom of the net cup. The cube wicks up moisture, the roots grow down into the solution, and the air gap forms as the plant drinks. For the full setup, see how to set up a Kratky tomato system.
Common Seedling Problems
| What you see | Likely cause | Fix |
|---|---|---|
| No sprouts after two weeks | Too cold, or old seed | Warm the tray to 70 to 80°F; try fresh seed |
| Long, thin, leaning stems | Too little light | Lower the light or move it closer |
| Seedlings collapse at the base | Damping off, from too much moisture and too little air | Keep cubes moist, not soaked; give some air movement |
| Pale or yellow first leaves | Hungry once the true leaves are out | Start a weak nutrient solution |
How long the whole journey takes, from this first seed to ripe fruit, is on the Kratky tomato timeline.
Back to the Kratky method for tomatoes.
Frequently Asked Questions
Can you start tomato seeds directly in a Kratky container?
Yes. Sow the seed in a cube that sits in the net cup, with the solution touching the bottom of the cup. Starting in a tray is easier, though, because you can choose the strongest seedlings.
How long until a tomato seedling can go into Kratky?
Usually a few weeks after sowing, once white roots grow out of the bottom of the cube.
Should tomato seedlings get nutrients?
Not until the first true leaves appear. Then use a weak solution, a quarter to half strength.
